安装要点:

供电电源为交流110V和交流220V两种接法,注意不同的接线端子。继电器输出触点只能连接在交流220V及以下的系统,过高的电压可能会损坏该触点。接近感应开关和码盘的配合要合适,距离过远可能会造成丢码。传感器的信号线尽量远离动力线。
调试要点(必要的3步)
A、请设定对应脉冲的系数
B、请检查电机运行方向和显示方向是否一致如果不一致请交換传感器的A、B信号输入线
C、请设定在当前位置希望显示的数值

Installation important:
Power source AC 110V AC 220V two-connection, note the different terminals. Relay output contacts can only be connected in the system up to the AC 220V, excessive voltage can damage the contacts. Proximity switch and codingappropriate co-ordination, is too far may result in losing yards. As far as possible from power cables from the signal of the sensor.
Debugging elements(essential 3 step)
A、 The coefficient a, set the corresponding pulse.
B、 Check that the motor direction and the direction is consistent; if not, swap sensors a, b signal input line.
C、 Set the values you want to display in the current location.